How to Repair a Saab 93 Key Fob
There is a good possibility that your Saab 9-3 key fob is faulty with its electronic chip. The metal component of classic car keys was easy to copy, but the modern keys have an immobilizer to safeguard your vehicle.
To find out why the key fob won't work and fix the issue, replace the battery in the coin. This is a low-cost and simple fix.
How do I program a Saab 93 Key Fob
Saab key fobs 93 allow you to control the doors of your car and trunk as well as the engine. They also allow you to unlock the fuel door and trigger a panic button. Remotes can be programmed by syncing them with the transmitter inside your vehicle. Plug the key into the ignition and turn the switch to ON. Follow the Tech2 instructions until you have programmed the keys that you wish to use with the vehicle.
New Saabs had two keys, while older models usually have only one. You can add a new key by replacing the transmitter, which includes the transponder, and programming it with a handheld device called a Tech-2. This is done at the Saab dealership. To make it work you'll require a matching key. This is a costly task however, it's less expensive than replacing your entire CIM system with locking cylinders, especially if you lose the sole functioning key.
Saab Key fob replacement 93
Saab owners who have lost their only key should replace it with an additional one as soon as is possible. The key fob is not like the traditional metal keys used in cars from 20 years ago. It is an electronic device that communicates with the car via a unique chip. This is how the car detects the key fob, and stops it from being copied. It is possible to do this at a dealer, however the cost can be high. It is better to avoid this problem by purchasing an replacement Saab key from an online retailer.
The main reason to have an additional key is to protect your vehicle if you ever lose it. A burglar is more likely locate a spare key rather than an unintentionally stolen one. The majority of thieves don't have the tools required to duplicate these modern keys. They'd need a specific device to copy them however, even that is not a foolproof method of protecting your vehicle from theft.
A spare key can also save you money when replacing the SAAB 9-3 remote's battery. All electronic units in the keyfob are powered by batteries, and eventually they'll fail. It is easy to change the battery, however it is important to take care not damage the electronics in the case. You can view videos on Youtube to learn the best way to do this job, like those by Cyclone Cyd.
Saab 93 key fob battery
If you've experienced delays in the response of your key fob, chances are it's time to replace the battery. Although there may be other causes behind the delay but a dead battery is the most likely cause. It's an inexpensive and simple fix, so you shouldn't wait to do it.
The first step is to take the backup key from the fob. To do this, push firmly on the Saab Logo and pull on the key ring loop. Put a flathead Phillips screwdriver through the indentation in the key fob case. Turn saab 9-5 key replacement G28 to separate the case. It shouldn't require a lot of force, but be cautious not to damage the plastic.
You can see the electronic components inside the case when you open it. The circuit board is attached to the retaining clips made of metal. If they are rusty or dirty the fob will not perform as it should. It is possible to clean the fobs using rubbing alcohol. This is only a temporary solution. The clips will break again eventually and require to be replaced.
Before replacing the battery, you need to test the door locks of your car using your backup remote. If your backup remote works, then the problem is most likely with your main key fob. If the issue persists even after replacing the battery, there might be an issue with your vehicle.
Saab keyfob case with 93 keys
A replacement case can be purchased when your key fob appears tired. They can be purchased on the internet and can be attached to your remote control. All you need is a flathead and a bit of patience. Insert the flathead screwdriver in the slot in the middle of the case and then gently open it. Be careful not to damage the limiters that protect the battery. The new case will be inserted into the existing electronics after taking out the emergency badge and key. It will require no modification.
The top key fob covers have a special inner lining that prevents signals from being transmitted to the key fob. This is essential, since it is the signals that allow your vehicle to start. Some of these cases are constructed with silver layers, whereas others are made of copper to make transmissions more distort.
A key fob cover is also an excellent way to protect your keys from being damaged. It can help you keep the track of your keys and will also help you find them in the dark while you're heading to your car. A quality key fob cover will safeguard your keys from theft, and will also add a touch of style to your keychain.